Want to know more?

Contact us

Wall Lighting



The Sparkle LED strip has 120 LEDs per metre, which uses 9.6W of power per metre.
The strip is supplied as 2500mm lengths (24W in total)

Can be cut at points indicated on the strip. Includes a 300mm cable with male connector (this is to be used only with a hard wired driver and to be installed by a qualified electrician). The Sparkle LED strip has a self adhesive backing tape and plastic fixing clips are supplied if required.

Once the tape has been cut, affix plastic end cap with silicon.

IP65 Rating (protected against dust and against sprays of water).

CRI > Ra 72

Luminous Flux: 600 lm per metre

Required Accessory (Not included)

An LED driver is required. The following option is available:
PLU 6723 ATCO SR8-25W Constant Voltage Dimmable LED Driver
Hard wired: Driver should be constant voltage
(Operating range 8-25W)

PLU 73302 CC32 LED Aluminium Channel 135cm length
When installing on a timber or painted surface the high power LED strip needs to be mounted in an aluminium channel (acts as a heat sink). The acrylic diffuser on the channel helps to soften the glare.


  • Ideal for general cove lighting
  • In interiors, use to highlight glass splash backs
  • Behind vanity mirrors, underneath kitchen island benches, under bathroom vanities


  • Length: 2500mm
  • Width: 8mm
  • Height: 3mm
For more information, please visit Cabinet Lighting.

Share your comments about this Collection 0 Comments

You must be logged in to comment. Please Log in or Register.